Summer home improvement to prepare your home for winter

Now that summer is not far away, it’s a good time to start planning. The summer months are a popular time for do-it-yourself work, as more free time is available and it is usually too cold to do anything when winter comes. Why not make a list of changes so you are thankful that you were done when it was warmer? Here are 5 ideas for summer improvements to your home.

Replacing the radiator

It is difficult to install new radiators in winter. This is because appointments are filled with people who have left it to the last minute and homeowners who have just turned on a radiator, only to find that it doesn’t suddenly work. As a result, DIY specialists are usually overrun at this point.

This crisis is avoided by deciding to take preventive measures at the beginning of the year. Another advantage is that you can selectively decide which of the designer radiators should look best in your home. You don’t just have to choose from what’s still in stock. Check out the collection Radiators only for inspiration. Your team strives to provide radiators with an attractive appearance that is supported by excellent customer service and a large selection of models.

Chase drafts or areas with heat loss

It goes hand in hand with a cooler change to look for places where heat is lost from the house and additional heating is needed to replace it continuously.

Windows and doors

The most common places where heat is lost in autumn and winter are doors and windows on the front or back of the house. Cracks in doors, door frames, window frames and window sills lead to small drafts that are barely noticeable at first but create a steady heat loss that adds up.

To fix these problems, move your hand over each door and window to feel a breeze. Then fill any cracks with sealant. After the seal has dried, you should add a glass sheet as an additional seal for each window. The heat of a hair dryer seals the film over the window frame, but can be easily removed if necessary.

Heat pipes

Adding delays to your water pipes, especially to the plastic pipes, prevents heat loss in your heating and water systems.

For winter, the additional delay also prevents pipes from freezing and breaking open. The last thing anyone wishes for, especially in winter, is a broken pipe and a flood in their home. Foam insulation is inexpensive, lasts a decade or more, and reduces energy costs every year.

Check the house and grounds for new problems

Take a stroll around the house and then walk through the front and back garden areas, which, as an inspector, look for problems that need to be fixed.

Wooden fences and gates

With the increasing storms and heavy rain, a fence may have seen a wooden slat that has been pushed out of place or is now broken. These can usually be attached, reinforced and resealed. If a wooden gate is damaged, do what you can to restore or replace it.

Water pooling areas

Look for problems with the pool water on the patio and other areas. These are likely to freeze in winter and become a danger. Check for an improved way to drain water into the sewage system before it reaches the area where it regularly collects.

Loft insulation

Around 25 percent of the heat is lost through a roof if the attic below is not properly insulated. If you’ve neglected the attic for too long, but know that it has always lacked insulation (or is too old to be effective at this point), it’s worth working on as long as it’s warmer up there.

Pitched roofs are the easiest to isolate – former or flat roofs are more difficult to handle.

There are Two main methods of isolating an attic::

1. Cold Loft – Insulation is placed over the ceiling and under the attic floor
2. Warm loft – The insulation is located directly under the roof, so that the loft also benefits from the heat in the house.

Over the years, the insulation thickness has steadily increased to over 250 mm for greater effectiveness. It is advisable to remove old, thin insulation when it can no longer be used. Then replace it with something far more robust.

Check your tools

It is never a bad idea to check that your tools are all in place, correct and working properly. If you rely on a leaf blower to work or a rake not to break to remove fallen leaves in the fall, check them before they become a wet mess for the winter.

If you need certain parts like screws, nails, washers, and more to solve DIY problems over the winter, make sure you have enough on hand. It saves you a trip to the DIY center in the cold.

Taking care of upgrades, improvements, and replenishments before winter reduces the likelihood that an issue will develop that will be more difficult to fix later. A little preventive DC goes far.